ACN IRIS X Installationsanleitung PDF herunterladen (Seite 47)

Troubleshooting

Please visit our website, acndigitalsupport.com, for the most up-to-date information on the IRIS X, including Installation,

Features, Applications, System Settings, Advanced Features and Troubleshooting.

I’m having problems installing my phone

1. Ensure installation was performed correctly and completely. (See Quick Installation Guide)

2. The ACN IRIS X requires a router. ACN recommends the Cisco Linksys E-1200. The IRIS X has two

Ethernet ports. Connect the Ethernet port before powering on the IRIS X. One port is labeled Network, the

other PC. The Network port should be connected to the router. A PC or other end device can be connected

to the PC port if desired. Verify your Internet connection is working properly by browsing to your favorite

website with a computer.

3. Check your power source. Check to ensure the power adapter is securely connected to the back of the IRIS

X. If the power adapter is plugged into a surge protector or power strip, make sure the power to the surge

protector is switched on. Make sure the Home Button light is illuminated or flashing.

4. Allow sufficient time for initial setup. Initial setup should be performed with the IRIS X connected to a wired

connection. The initial setup may take 10-20 minutes to complete depending on your Internet speed. The

phone may reboot 2-3 times. The phone may present a Setup screen and/or Firmware Upgrade screen. No

you interaction is needed in these screens. The phone may present a calibration screen. Make sure to

complete the calibration steps when presented. Please do not disconnect your IRIS X or attempt to make

calls until installation is complete. Installation is complete when your phone number is shown in green on the

home screen Info widget.

5. Installation of the IRIS X is complete when the Info widget on the Home screen shows a green icon on the

top right and you have an IP address in the bottom line of the Info widget.

Phone does not recognize input on the touch screen

Screen Calibration allows adjustment of the touch sensitive screen so that when you make a selection on the screen,

the phone correctly recognizes the selection.

1. For best performance, use the stylus with the IRIS X. The stylus is designed to provide an optimal experience

with the IRIS X touch screen.

2. When the IRIS X Video Phone has been idle for some time, you may experience a slight delay when you

initially press the screen to initiate an action.

3. If there is no response, it is possible the screen needs calibration which can be performed by following the

calibration steps.

a. Method 1: Go to Menu – System Settings – Maintenance – Factory Functions – Touch Screen

Calibration. Follow the on screen instructions.

b. Method 2: If the Method 1 above does not correct the issue, use this method. Press and hold the

Home button for approximately 1 second, then press and hold the Home button for 10 seconds.

Upon releasing the Home button after 10 seconds, the Touch Screen calibration utility will be

presented. (You may have to repeat this process to access the Calibration screen.) Once the

calibration screen is displayed, touch the cross hairs in each of the five locations displayed on the

screen with the stylus, then press the Home button to complete the calibration.

4. If too many applications or widgets are open, the IRIS X may become sluggish or lose registration. A

maximum of 10 total widgets can be open at any one time. Only 3 instances of each widget can be open,

with the exception of the Contacts widget which only permits one instance. To close a widget, press and hold

on the widget until the close option appears and press the close option.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

ACN IRIS X Installationsanleitung Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Telefone ACN IRIS X